はじめに

This guide informs you on the proper way to remove the bumper buttons on the PowerA Spectra Controller.

The bumper buttons are two identical buttons located on top of the controller directly across from each other. These buttons may have to be replaced due to worn out springs or joints.

Make sure to disconnect any electrical connections before maintenance.

必要な工具と部品

手順1 Rear Case

PowerA Spectra Contoller Bumper Replacement, Rear Case: 手順 1、 1の画像 1

Flip the controller over so the backplate is facing up.

編集

手順2

Use a Phillips #2 screwdriver to remove the eight 7.8 mm screws that secure the rear case.

編集

手順3

Hold the front case in one hand and pull the rear case off.

編集

手順4 Bumper

PowerA Spectra Contoller Bumper Replacement, Bumper: 手順 4、 1の画像 1

Remove the two 7.8 mm screws from the motherboard with a Phillips screwdriver.

編集

手順5

Grasp the front plate and motherboard and slowly pull apart to access the bumpers.

編集

手順6

Use angled tweezers to unclip the bumper spring from the front plate.

編集

手順7

Lift up the bumper and slide off the bumper axis to remove.

編集

終わりに

To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.