はじめに

This guide takes you through installing the SIM card reader on the PlayStation Vita.

  1. Power off and remove the memory card.
    • Power off and remove the memory card.

    • Using a Phillips #00 screwdriver, remove the four 6.4mm screws on the back casing.

    コメントを追加する

  2. Using your fingernail or a spudger, pry open the accessory port cover on the top of the device.
    • Using your fingernail or a spudger, pry open the accessory port cover on the top of the device.

    • Using a Phillips #00 screwdriver, remove the two 5.4mm screws hidden beneath the accessory port cover.

    コメントを追加する

    • Remove the two 5.4mm Phillips #00 screws on the bottom of the device near the charging port.

    コメントを追加する

    • Beginning at the sides of the device, use a plastic opening tool to separate the front and rear cases.

    • Continue working your way around the device gently prying it open.

    • There are still wires holding the front and rear cases together. You may damage the connections if you yank the cases completely apart.

    コメントを追加する

    • Gently separate the two cases, minding the battery and the touch screen controller connectors holding the two cases together.

    コメントを追加する

    • Using a spudger, free the touch screen controller flex cable by gently prying up the connection.

    コメントを追加する

    • Free the battery cable by gently prying up on the connection with a spudger.

    Any idea what type of pcb header is on the board for the battery? I have a motherboard with a broken header but I cant source a replacement

    Jimbo Jones - 返信

    This is where I screwed up so I recommend extra caution for other newbies. Only the black part is supposed to come off. Don't be an idiot like me and pry off too much...

    ylimakiminna - 返信

    Yea I messed up there too. Is there a way to fix it?

    Alethia Henry - 返信

    • Separate the front and rear cases.

    コメントを追加する

    • Gently pry open the tab of the flex cable socket on top of the SIM card reader.

    • Free the flex cable by sliding the spudger underneath it and pulling it out of the socket. Rest the flex cable out of the way.

    コメントを追加する

    • Use a spudger to release the plastic tab along the inside of the case and gently pry up the SIM card reader.

    コメントを追加する

    • Lift the SIM card reader out of the casing.

    • Using a Phillips #00 screwdriver, remove the blue, 5.0mm screw from the SIM car reader.

    • Separate the SIM card reader from the SIM card reader retainer.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Brittany McCrigler

メンバー登録日: 2012年03月05日

79,859 ポイント

133のガイドは作成済み

チーム

iFixit iFixit人のメンバー

Community

114 メンバー

6,995のガイドは作成済み

コメント1件

I have an error relating to the reader on my Vita. If I took it out without replacing it, will it cause the same or different error so I have to replace it, or will it be (somewhat) fine??

christoffersen366 - 返信

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 5

過去 30 日: 25

今までの合計 6,149