はじめに
Follow the procedure outlined in this guide to remove and install the circuit board for the device's bottom buttons.
必要な工具と部品
-
-
-
Pry off the four white feet with the pointed end of the spudger
FixBotに聞いてみる
-
-
-
Gently unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.
-
-
-
-
Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.
-
-
-
Carefully pull up and out the four electrical connectors and two ribbon connectors that connect the bottom panel to the dock.
-
Electrical Connectors
-
Ribbon Connectors
-
-
-
-
-
Unscrew the ten 6 mm Phillips #00 screws holding the board in place.
-
-
To reassemble your device, follow these instructions in reverse order.
チーム
Cal Poly, Team 3-48, Amido Spring 2013 Cal Poly, Team 3-48, Amido Spring 2013人のメンバー
CPSU-AMIDO-S13S3G48
4 メンバー
31のガイドは作成済み
1件のガイドコメント
My philips dc 320 /37 A do not sown time digits and frecvency digits . Where can I find schematic diagram?
Thank you
