メインコンテンツにスキップ

Parrot AR.Drone 2.0 Motor Replacement

必要な工具と部品

ビデオの概要

  1. Parrot AR.Drone 2.0 Motor Replacement, Propeller and Gear: 手順 1、 2の画像 1 Parrot AR.Drone 2.0 Motor Replacement, Propeller and Gear: 手順 1、 2の画像 2
    • Remove the foam body.

  2. Parrot AR.Drone 2.0 Motor Replacement: 手順 2、 2の画像 1 Parrot AR.Drone 2.0 Motor Replacement: 手順 2、 2の画像 2
    • Disconnect the battery by pulling the two red wires apart.

    • Remove the battery by releasing the battery retaining straps.

  3. Parrot AR.Drone 2.0 Motor Replacement: 手順 3、 1の画像 1
    • Remove the small retaining clip using a plastic opening tool.

    • Be careful as these clips can fly off and can be difficult to find.

  4. Parrot AR.Drone 2.0 Motor Replacement: 手順 4、 3の画像 1 Parrot AR.Drone 2.0 Motor Replacement: 手順 4、 3の画像 2 Parrot AR.Drone 2.0 Motor Replacement: 手順 4、 3の画像 3
    • The propeller, gear, and rod can be removed by simply lifting them off the motor.

  5. Parrot AR.Drone 2.0 Motor Replacement, Motor: 手順 5、 2の画像 1 Parrot AR.Drone 2.0 Motor Replacement, Motor: 手順 5、 2の画像 2
    • Disconnect the connector at the bottom of the motor assembly.

  6. Parrot AR.Drone 2.0 Motor Replacement: 手順 6、 1の画像 1
    • Remove the three 5mm screws on the top of the motor assembly with a PH00 bit.

  7. Parrot AR.Drone 2.0 Motor Replacement: 手順 7、 1の画像 1
    • Remove the three 5mm screws on the bottom again using a PH00 bit.

    • The three screws from the top are different from the three screws on the bottom.

  8. Parrot AR.Drone 2.0 Motor Replacement: 手順 8、 2の画像 1 Parrot AR.Drone 2.0 Motor Replacement: 手順 8、 2の画像 2
    • Carefully wiggle out the motor assembly out of the arm.

終わりに

To reassemble your device, follow these instructions in reverse order.

5 の人々がこのガイドを完成させました。

作成者

10人の作成者と共同で作成されました。

David Hoyt

メンバー登録日: 04/09/10

4,023 ポイント

43のガイドは作成済み

チーム

Cal Poly, Team 25-89, Amido Spring 2010 Cal Poly, Team 25-89, Amido Spring 2010人のメンバー

CPSU-AMIDO-S10S25G89

4 メンバー

63のガイドは作成済み

2 件のコメント

are the motors different on each side?

dbksoft - 返信

I need to know this also. replaced cross.member but did not put motors in original spots now my drone goes crazy and erratic

Steven Maloney -

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 5

過去 30 日: 14

今までの合計 5,687