Panasonic VDR-D220 DVD AV and Micro USB Data Ports Replacement

はじめに

If you are unable to complete transfer of data due to a loose connection this guide will show you how to replace the AV and micro USB ports. These ports commonly get pushed into the device and the contacts break due to usage.

必要な工具と部品

手順1 AV and Micro USB Data Ports

Panasonic VDR-D220 DVD AV and Micro USB Data Ports Replacement, AV and Micro USB Data Ports: 手順 1、 3の画像 1

Panasonic VDR-D220 DVD AV and Micro USB Data Ports Replacement, AV and Micro USB Data Ports: 手順 1、 3の画像 2

Panasonic VDR-D220 DVD AV and Micro USB Data Ports Replacement, AV and Micro USB Data Ports: 手順 1、 3の画像 3

Use your Phillips #0 screwdriver to remove the three 5mm screws on top of the camera.
Remove the metal bracket.

翻訳

手順2

Rotate the camera to show the bottom of the camera.
Remove the four 5mm screws on the bottom side of the camera with a Phillips #0 driver.

翻訳

手順3

Rotate the camera to the left side. There is one screw on the top right of metal bracket you have removed in step 1.
Remove one 5mm screw by using Phillips #0 screwdriver.

翻訳

手順4

Use a plastic spudger to lighty pry the top-front panel of the camera from the main body.
Slide the top portion of the camera forward revealing more screws.
Do not completely separate the top portion yet, as there are cable connections that remain.

翻訳

手順5

Panasonic VDR-D220 DVD AV and Micro USB Data Ports Replacement: 手順 5、 3の画像 3

Flip the camera on the right side.
Gently pull the front part from the main body to expose the cable connections.
Pulling too hard or fast has the potential to damage the ZIF connector cable.
Use your plastic opening tool to disconnect the connection point safely.
Press the tab with plastic opening tool and then pull the ZIF connector to detach.

翻訳

手順6

Flip the camera to see the top side of it.
Remove one more 5mm screw with your Phillips #0 screwdriver that was previously covered by the front-top section.

翻訳

手順7

Go to the battery's basement side.
Use your Phillips #0 screwdriver remove the two 5mm screws on the battery base of the camera.

翻訳

手順8

Panasonic VDR-D220 DVD AV and Micro USB Data Ports Replacement: 手順 8、 3の画像 3

Rotate the camera to the left side, where the side port is located.
Open the side port door.

翻訳

手順9

Panasonic VDR-D220 DVD AV and Micro USB Data Ports Replacement: 手順 9、 3の画像 3

Remove three 5mm screws inside the side ports by using Phillips #0 screwdriver.
Start to lift the lefthand section of the camera from the main body.
Don't fully remove the section just yet as there are cable connections that remain.

翻訳

手順10

Panasonic VDR-D220 DVD AV and Micro USB Data Ports Replacement: 手順 10、 3の画像 3

Rotate the camera to the battery side.
Gently, pull the side of the camera apart with only your hands.
Do not pull too hard because of the ZIF connector cable.
Disconnect the ribbon cable with your plastic opening tool, so that the left side of the camera can be removed.

翻訳

手順11

Remove one 5mm screw from the side of the battery base with the Phillips #0 screwdriver.
Take off the battery's base from the camera.

翻訳

手順12

Rotate the camera to the bottom side.
Remove six 5mm screws with your Phillips #0 driver and the circuit board holder should come free.

翻訳

手順13

Insert a Jimmy tool to relieve the pressure between the metal mount and the plastic cover.
Take off the port board from the bottom of the camera.

翻訳

手順14

Panasonic VDR-D220 DVD AV and Micro USB Data Ports Replacement: 手順 14、 3の画像 3

Use your Phillips #0 screwdriver remove one 5mm screw from one side of the port.
On the other side, disconnect the metal from the port circuit board smoothly.

翻訳