はじめに

Use this guide to replace the back cover which houses the back panel buttons and LCD screen.

パーツ

パーツは必要ありません。

  1. Remove the following eleven screws securing the covers to the ZS3
    • Remove the following eleven screws securing the covers to the ZS3

      • Eleven 3 mm Phillips screws

    • Using too much pressure when removing the screws may strip the screws and complicate screw removal at a later time.

  2. Use the flat end of a spudger to pry apart the back cover from the rest of the unit as shown.
    • Use the flat end of a spudger to pry apart the back cover from the rest of the unit as shown.

    • Be sure to carefully and slowly lift the back cover. Forcefully lifting the back cover and fully separating it at this point may ruin internal connections.

    • Using your fingernail or a spudger, flip up the ZIF locking flap on the two LCD ribbon cable sockets that connect the back cover to the rest of the unit.

    • Be sure you are opening the locking tab, not pulling against the socket mounted to the board.

    • Remove the two LCD board ribbon cables out of their sockets.

まとめ

To reassemble your device, follow these instructions in reverse order.

Juan Pablo Quinonez Weston

メンバー登録日: 2013年04月16日

4 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 13-60, Johann Spring 2013 Cal Poly, Team 13-60, Johann Spring 2013人のメンバー

CPSU-JOHANN-S13S13G60

3 メンバー

5のガイドは作成済み

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 637