はじめに

How remove the outer casing

パーツ

パーツは必要ありません。

Lay device face down on surface.
  • Lay device face down on surface.

コメントを追加する

Heat the left and top edges with hairdryer for one minute. Move hairdryer back and forth to evenly heat up surface.
  • Heat the left and top edges with hairdryer for one minute.

  • Move hairdryer back and forth to evenly heat up surface.

  • Caution: directly heating the screen can melt or distort the screen.

コメントを追加する

MacBook Battery Fix Kits
Fix Kits Starting at $69.99
MacBook Battery Fix Kits
Starting at $69.99
Use tweezers to hold Palm right side down on it's side.
  • Use tweezers to hold Palm right side down on it's side.

  • Use a plastic opening tool to pry open front and back casing.

  • If you are unable to open you may need to heat with hairdryer for longer.

  • Be sure not to touch case directly with fingers, it will be hot!

コメントを追加する

Leave plastic opening tools in between front and back casing.
  • Leave plastic opening tools in between front and back casing.

  • Rotate Palm and repeat steps 2 and 3 for right and back edges.

コメントを追加する

Now pry open front and back casing with plastic opening tools. Separate front and back casing completely. Power button will fall off once front and back casing have been removed. Be sure not to lose it.
  • Now pry open front and back casing with plastic opening tools.

  • Separate front and back casing completely.

  • Power button will fall off once front and back casing have been removed. Be sure not to lose it.

コメントを追加する

ゴール

Anthony Platt

メンバー登録日: 2010年02月09日

24 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 13-25, Maness Winter 2010 Cal Poly, Team 13-25, Maness Winter 2010人のメンバー

CPSU-MANESS-W10S13G25

4 メンバー

4のガイドは作成済み

コメント1件

So...This given by my grandmother and it is out of battery. Unluckily, it won't charge, because the %#*@ old battery had gone kaput. I had a hard time finding one that might be suitable, and turnout that I need to insert it into the device and connect it to the circuit board. I have some solid soldering skills, but without a heat gun, the andonized cover won't come off. And what's more, I jammed a pencil tip into the "reset" hole when trying to reset the device. Thinking the big opening was a kind of cover-releasing button...I was just having a whole lot of trouble and thinking too much. !&&*.

Xavier Jiang - 返信

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 1,318