パーツ

パーツは必要ありません。

  1. Remove protective flap by pulling directly out from the top.
    • Remove protective flap by pulling directly out from the top.

    • The two clips will pop out

    コメントを追加する

  2. Remove Faceplate. There is a tab where the finger is located in the picture that needs to be pulled up.
    • Remove Faceplate. There is a tab where the finger is located in the picture that needs to be pulled up.

    • The Faceplate will then easily lift off.

    コメントを追加する

    • Using a a T5 Torx bit screwdriver, remove the four screws located on the back of the device turning counter clockwise.

    • The link to purchase this screwdriver is Located here.

    コメントを追加する

    • This is what the device looks like once you have taken the screws out and opened the device.

    コメントを追加する

    • The Motherboard and screen will pop out of the back case easily.

      • Be careful when doing this step, the components are fragile.

    コメントを追加する

    • To remove the screen from the motherboard there are going to be three tabs that need to pulled up.

    • ** This step needs to be done with special care because it is very fragile.**

    • Once they are all three popped up the motherboard and screen will separate easily.

    コメントを追加する

    • Click here for Palm m105 screen replacement

    • Now that the screen and motherboard are separated you may discard the broken screen. The best way to dispose of the broken screen is to: Recycle it

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Erik Thompson

メンバー登録日: 2011年10月04日

31 ポイント

5のガイドは作成済み

チーム

UW Stout, Team 1-3, Zhou Fall 2011 UW Stout, Team 1-3, Zhou Fall 2011人のメンバー

UWSTOUT-ZHOU-F11S1G3

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 430