メインコンテンツにスキップ

Palm m 100 Display Screen Replacement

必要な工具と部品

  1. Palm m 100 Display Screen Replacement, Display Screen: 手順 1、 1の画像 1
    • Remove the batteries.

  2. Palm m 100 Display Screen Replacement: 手順 2、 1の画像 1
    • Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.

  3. Palm m 100 Display Screen Replacement: 手順 3、 1の画像 1
    • Remove rear cover by gently lifting it up from the bottom.

  4. Palm m 100 Display Screen Replacement: 手順 4、 1の画像 1
    • Carefully lift up the circuit board, which will also lift up the screen. Do so carefully to prevent breaking the connectors.

    • Lift the left side of the circuit board and open it as though it were a book.

  5. Palm m 100 Display Screen Replacement: 手順 6、 1の画像 1
    • Unplug the three connectors located on the right side of the circuit board with great caution and care. Do not pull by the cable, and be sure to pull the connector itself gently.

    • After separating the screen from the board, set aside the old display screen.

    • Replace with a new display screen.

  6. Palm m 100 Display Screen Replacement: 手順 9、 1の画像 1
    • Plug in the three connectors.

  7. Palm m 100 Display Screen Replacement: 手順 10、 1の画像 1
    • Close again like a book, and lay it gently into the front panel, screen facing outwards of the front panel.

  8. Palm m 100 Display Screen Replacement: 手順 11、 1の画像 1
    • Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

4人の作成者と共同で作成されました。

Lexi Gallucci

メンバー登録日: 10/18/11

11 ポイント

2のガイドは作成済み

チーム

James Madison, Team 1-3, Allen Fall 2011 James Madison, Team 1-3, Allen Fall 2011人のメンバー

JMU-ALLEN-F11S1G3

5 メンバー

5のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 683