メインコンテンツにスキップ

Palm m 100 Cover Replacement

必要な工具と部品

  1. Palm m 100 Cover Replacement, Cover: 手順 1、 1の画像 1
    • Remove the batteries.

  2. Palm m 100 Cover Replacement: 手順 2、 1の画像 1
    • Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.

  3. Palm m 100 Cover Replacement: 手順 3、 3の画像 1 Palm m 100 Cover Replacement: 手順 3、 3の画像 2 Palm m 100 Cover Replacement: 手順 3、 3の画像 3
    • Remove rear cover by gently lifting it up from the bottom. To remove the front cover, flip the device over, and then separate the screen/circuit board from the cover.

  4. Palm m 100 Cover Replacement: 手順 4、 1の画像 1
    • Set aside broken cover, and replace with a new cover.

  5. Palm m 100 Cover Replacement: 手順 5、 1の画像 1
    • Close again like a book, and lay it gently into the front panel. Make sure the screen is facing outwards of the front panel.

  6. Palm m 100 Cover Replacement: 手順 6、 1の画像 1
    • Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

4人の作成者と共同で作成されました。

Anne Carey

メンバー登録日: 10/25/11

1 ポイント

3のガイドは作成済み

チーム

James Madison, Team 1-3, Allen Fall 2011 James Madison, Team 1-3, Allen Fall 2011人のメンバー

JMU-ALLEN-F11S1G3

5 メンバー

5のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 537