はじめに

This guide will help you access and replace the Treo's camera if it is no longer functional.

Position the phone so the screen faces down.
  • Position the phone so the screen faces down.

  • Remove the stylus found on the back of the phone.

コメントを追加する

To remove the battery cover, hold down the button in the middle of the phone's back.
  • To remove the battery cover, hold down the button in the middle of the phone's back.

  • Slide the cover down to remove. Set the cover aside.

コメントを追加する

Lift the edge of the battery, separating contact points, and pull out as pictured. Lift the edge of the battery, separating contact points, and pull out as pictured.
  • Lift the edge of the battery, separating contact points, and pull out as pictured.

コメントを追加する

Remove the small round rubber cover on the back of the phone located immediately below the antenna.
  • Remove the small round rubber cover on the back of the phone located immediately below the antenna.

  • This will uncover a screw that will be removed in the next step.

コメントを追加する

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver. Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver. Pull out antenna.
  • Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver.

  • Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver.

  • Pull out antenna.

コメントを追加する

Pry the back cover off using a spudger or similar tool. The back cover is attached by several small clips on the inside.
  • Pry the back cover off using a spudger or similar tool.

  • The back cover is attached by several small clips on the inside.

コメントを追加する

Remove the two 3.75 mm screws. Pull off the logic board. Pull off the logic board.
  • Remove the two 3.75 mm screws.

  • Pull off the logic board.

コメントを追加する

Pull the rubber ring off of the camera. Pull the rubber ring off of the camera. Pull the rubber ring off of the camera.
  • Pull the rubber ring off of the camera.

コメントを追加する

Pry off the metal camera case. Lift up the camera, but do not remove. The connector must be detatched first.
  • Pry off the metal camera case.

  • Lift up the camera, but do not remove. The connector must be detatched first.

コメントを追加する

Pry off the camera connector plug. Remove the camera.
  • Pry off the camera connector plug.

  • Remove the camera.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

cgood

メンバー登録日: 2009年10月28日

116 ポイント

14のガイドは作成済み

チーム

Cal Poly, Team 19-3, Maness Fall 2009 Cal Poly, Team 19-3, Maness Fall 2009人のメンバー

CPSU-MANESS-F09S19G3

4 メンバー

18のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 1,956