メインコンテンツにスキップ

はじめに

If your camera doesn't work and it needs to be replaced, this guide will come in handy.

  1. On the back of the device, locate the 3 rubber plugs, and use a plastic spudger to remove them.
    • On the back of the device, locate the 3 rubber plugs, and use a plastic spudger to remove them.

  2. Use the T6 Torx Screwdriver to remove all 4 screws. You have to first remove the Stylus to  access the 4th screw.
    • Use the T6 Torx Screwdriver to remove all 4 screws.

    • You have to first remove the Stylus to access the 4th screw.

  3. Using a plastic opening tool, carefully separate the front and back cases. Note: The antenna will detach from the phone.
    • Using a plastic opening tool, carefully separate the front and back cases.

    • Note: The antenna will detach from the phone.

  4. Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now

    Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now
  5. Using the Phillips #00 screwdriver, unscrew the 4 screws holding the silver casing down.
    • Using the Phillips #00 screwdriver, unscrew the 4 screws holding the silver casing down.

  6. Lift up the silver casing.
    • Lift up the silver casing.

    • Careful! The casing is connected to the body. Pull the casing up.

  7. With the silver casing removed, unscrew two black screws with a #00 Phillips Screwdriver.
    • With the silver casing removed, unscrew two black screws with a #00 Phillips Screwdriver.

  8. Use the spudger to lift the logic board from its socket.  Remove it from the rest of the phone. Use the spudger to lift the logic board from its socket.  Remove it from the rest of the phone.
    • Use the spudger to lift the logic board from its socket. Remove it from the rest of the phone.

  9. Using the flat end of the spudger, lift the metal case off of the camera. Using the flat end of the spudger, lift the metal case off of the camera.
    • Using the flat end of the spudger, lift the metal case off of the camera.

  10. Slide the flat end of the spudger between the printed circuit board and metal holder. Pop the camera up Pop the camera up
    • Slide the flat end of the spudger between the printed circuit board and metal holder.

    • Pop the camera up

まとめ

To reassemble your device, follow these instructions in reverse order.

Clement Poisson

メンバー登録日: 2010年01月26日

24 ポイント

7のガイドは作成済み

チーム

Cal Poly, Team 13-23, Maness Winter 2010 Cal Poly, Team 13-23, Maness Winter 2010人のメンバー

CPSU-MANESS-W10S13G23

4 メンバー

16のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,489