はじめに

Use this guide to replace your PSP Go's top cover.

  1. Unscrew the four Phillips screws on the back of the PSP Go.
    • Unscrew the four Phillips screws on the back of the PSP Go.

    • Rotate the PSP so you can see the top of the device.

    • Unscrew the two Phillips screws next to the volume buttons.

    コメントを追加する

  2. Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.
    • Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

    • Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

    • Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

    コメントを追加する

    • Pull the top cover upwards gently from its housing.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Walter Galan

568,449 ポイント

1,203のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 3

過去 30 日: 6

今までの合計 5,129