はじめに

Use this guide to replace your PSP Go's headphone jack!

Unscrew the four Phillips screws on the back of the PSP Go.
  • Unscrew the four Phillips screws on the back of the PSP Go.

  • Rotate the PSP so you can see the top of the device.

  • Unscrew the two Phillips screws next to the volume buttons.

コメントを追加する

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.
  • Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

  • Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

  • Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

コメントを追加する

  • Pull the top cover upwards gently from its housing.

コメントを追加する

  • Remove the two Phillips screws holding the bottom plate.

  • Gently lift the bottom plate away from the device.

コメントを追加する

  • Remove the black Phillips screw holding the headphone jack in place.

コメントを追加する

  • Use a pair of tweezers and grasp the black plastic portion of the headphone jack cable.

  • Slowly pull out the cable. If it's hard to pull, wiggle it slightly side-to-side while pulling it.

  • Plugging the new headphone jack into place will require some force. Make sure not to break the connector while performing this procedure. Grasp the black plastic portion of the cable and wiggle it into the logic board connector.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Miroslav Djuric

143,089 ポイント

145のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 2

過去 30 日: 12

今までの合計 9,723