はじめに

Use this guide to remove the PSP Go's bottom plate!

Unscrew the four Phillips screws on the back of the PSP Go. Rotate the PSP so you can see the top of the device.
  • Unscrew the four Phillips screws on the back of the PSP Go.

  • Rotate the PSP so you can see the top of the device.

  • Unscrew the two Phillips screws next to the volume buttons.

コメントを追加する

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides. Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).
  • Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

  • Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

  • Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

コメントを追加する

MANTA DRIVER KIT
112 bit driver kit $59.99
MANTA DRIVER KIT
112 bit driver kit $59.99
Pull the top cover upwards gently from its housing.
  • Pull the top cover upwards gently from its housing.

コメントを追加する

Remove the two Phillips screws holding the bottom plate. Gently lift the bottom plate away from the device.
  • Remove the two Phillips screws holding the bottom plate.

  • Gently lift the bottom plate away from the device.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Miroslav Djuric

140,788 ポイント

236のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 7

今までの合計 6,408