はじめに

Steps for replacing malfunctioned directional pads in a Sony PSP-3000

Place the PSP face down and locate the battery cover on the left side of the device.
  • Place the PSP face down and locate the battery cover on the left side of the device.

  • Lift and remove the battery cover to reveal the battery.

  • Remove the battery.

コメントを追加する

Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.
  • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

コメントを追加する

  • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.

    • Two are located behind the battery's warranty sticker.

    • Two are located on the right side of the PSP.

コメントを追加する

  • Next, unscrew the two screws located at the top of the PSP.

コメントを追加する

  • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

コメントを追加する

  • Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.


  • Remove the front casing completely.

コメントを追加する

  • Peal up the rubber pad that is securing the D-pad buttons to the backside of the front casing.

  • Remove the D-pad and the rubber piece.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

mbnewsom

メンバー登録日: 2009年10月28日

2,357 ポイント

11のガイドは作成済み

コメント1件

Is it for 2000?

Kaio Igor - 返信

コメントを追加する

統計データを表示:

過去 24時間: 2

過去 7 日: 6

過去 30 日: 31

今までの合計 5,606