PSP 1000 Front Casing Replacement

はじめに

This guide will show you how to remove the PSP's housing/frame.

必要な工具と部品

手順1 Battery

PSP 1000 Front Casing Replacement, Battery: 手順 1、 1の画像 1

Turn the PSP over so its back is facing you.

翻訳

手順2

Locate the battery casing button on the rear-left side of the PSP.
Press down the button and remove the battery cover.

翻訳

You are dumbbb... BRO YOUR DUMB BC U DIDNT HAVE TO USE A TOOL TO OPEN THE DOOR. USE YOUR FINGER""

Paulo Moments - 2023年5月2日返信

The battery door can be damaged dont use a tool

Paulo Moments - 2023年5月2日返信

That also happend to me it got destroyed by screwdriver

Paulo Moments - 2023年5月2日返信

手順3

Using your finger, remove the battery upwards from the system as shown.

翻訳

The use of the opening tool is completely unnecessary. There is a finger actuated opening latch button that says “PUSH” on it. Simply press down with your thumb then slide your thumb down and away, dragining the battery door with it. It will then come off. Assuming the system still has its original plastics, they may have become brittle enough that the opening tool could damage the release button or the plastic cover.

Franklin Allen - 2021年8月8日返信

手順4 Front Casing

PSP 1000 Front Casing Replacement, Front Casing: 手順 4、 2の画像 1

PSP 1000 Front Casing Replacement, Front Casing: 手順 4、 2の画像 2

Remove the four screws shown with a Phillips #00 screwdriver.
You will have to peel back the guarantee sticker to access the screw on the lower left.

翻訳

Much luck to you if you have a tiny, metal screwdriver like I did, the screws might be stuck in there and may require some force.

Squib - 2017年8月14日返信

you need to peel back the warranty sticker in order to access both the lower left and lower left screws

Frederick zzstu Geib - 2020年3月18日返信

This is a bit misleading, you should only remove the two black screws in the battery compartment. The silver ones can stay.

Damian Cartwright - 2020年10月21日返信

The two left hand screws won’t come out of mine

XULF - 2022年6月8日返信

iFixit screwdriver bits aren't thin enough to reach the two screws on the right near the memory stick slot.

Fliggle_Slaps - 2023年1月20日返信

Can't edit previous comment so here's a new one:

Standard or older iFixit screwdriver bits aren't thin enough to reach the two screws on the right near the memory stick slot. You'll need precision bits that have longer tips to reach these deep screws.

Fliggle_Slaps - 2023年1月20日返信

手順5

Remove the screw from the bottom side of the PSP. Keep it separated from the rest of the screws.
Remove screws from back righthand side within the holes.

翻訳