メインコンテンツにスキップ

はじめに

Follow this guide in order to fix the cameras in your Oregon Scientific Meep! X2 tablet.

パーツ

パーツは指定されていません。

  1. Remove the orange covers from the left and right sides of the device by sliding up against the tabs.
    • Remove the orange covers from the left and right sides of the device by sliding up against the tabs.

  2. You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device. You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device. You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.
    • You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.

  3. Use the plastic opening tools to undo the clips around the edges of the device. Use the plastic opening tools to undo the clips around the edges of the device. Use the plastic opening tools to undo the clips around the edges of the device.
    • Use the plastic opening tools to undo the clips around the edges of the device.

  4. Slip the plastic opening tool under the white, square enclosure of the camera and lift upward to unhook the camera unit from the motherboard. Slip the plastic opening tool under the white, square enclosure of the camera and lift upward to unhook the camera unit from the motherboard.
    • Slip the plastic opening tool under the white, square enclosure of the camera and lift upward to unhook the camera unit from the motherboard.

  5. Pry the second camera out of its slot with one of the plastic opening tools. Be sure to undo the black adhesive foam from the metal casing in order to remove the camera properly.
    • Pry the second camera out of its slot with one of the plastic opening tools.

    • Be sure to undo the black adhesive foam from the metal casing in order to remove the camera properly.

  6. Release the black security clip on the ribbon cable with your plastic opening tool.
    • Release the black security clip on the ribbon cable with your plastic opening tool.

    • Gently disconnect the gold ribbon cable from the motherboard. The two cameras will remain attached to the ribbon cable.

終わりに

To reassemble your device, follow these instructions in reverse order.

J'mel Henneman

メンバー登録日: 2015年01月20日

864 ポイント

8のガイドは作成済み

チーム

USF Tampa, Team 9-1, Blackwell Winter 2015 USF Tampa, Team 9-1, Blackwell Winter 2015人のメンバー

USFT-BLACKWELL-W15S9G1

3 メンバー

16のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 6

今までの合計 137