メインコンテンツにスキップ

はじめに

Use this guide to help repair a faulty battery in the Oregon Scientific Meep! X2 tablet.

  1. Remove the orange covers from the left and right sides of the device by sliding up against the tabs.
    • Remove the orange covers from the left and right sides of the device by sliding up against the tabs.

  2. You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device. You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device. You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.
    • You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.

  3. PCラップトップ用バッテリー

    An easy fix for a big power boost.

    ショップを見る

    PCラップトップ用バッテリー

    An easy fix for a big power boost.

    ショップを見る
  4. Use the plastic opening tools to undo the clips around the edges of the device. Use the plastic opening tools to undo the clips around the edges of the device. Use the plastic opening tools to undo the clips around the edges of the device.
    • Use the plastic opening tools to undo the clips around the edges of the device.

  5. Gently unhook the black security clips to loosen the ribbon cable. Use one of the plastic opening tools. Pull lightly on the ribbon cable to remove it. Pull lightly on the ribbon cable to remove it.
    • Gently unhook the black security clips to loosen the ribbon cable. Use one of the plastic opening tools.

    • Pull lightly on the ribbon cable to remove it.

  6. Use your spudger to separate the battery from the adhesive glue strips and plastic film. Use your spudger to separate the battery from the adhesive glue strips and plastic film.
    • Use your spudger to separate the battery from the adhesive glue strips and plastic film.

  7. Use a soldering station to unsolder the battery wires from the motherboard. In the case of screen or screen sensor replacement, disregard desoldering steps.
    • Use a soldering station to unsolder the battery wires from the motherboard.

    • In the case of screen or screen sensor replacement, disregard desoldering steps.

まとめ

To reassemble your device, follow these instructions in reverse order.

J'mel Henneman

メンバー登録日: 2015年01月20日

855 ポイント

8のガイドは作成済み

チーム

USF Tampa, Team 9-1, Blackwell Winter 2015 USF Tampa, Team 9-1, Blackwell Winter 2015人のメンバー

USFT-BLACKWELL-W15S9G1

3 メンバー

16のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 10

今までの合計 1,108