メインコンテンツにスキップ

はじめに

Removal of the front plate to get into the logic board, lens, etc.

パーツ

パーツは指定されていません。

  1. Flip camera so you are looking at the bottom.
    • Flip camera so you are looking at the bottom.

    • Unscrew all 5 base plate screws.

  2. Lift open retainer clip by sliding the clip to the left and letting the clip pop up.
    • Lift open retainer clip by sliding the clip to the left and letting the clip pop up.

  3. Unscrew the single screw located next to the battery slot.
    • Unscrew the single screw located next to the battery slot.

  4. Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る

    Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る
  5. Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.
    • Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.

    • Lift the rubber plate exposing the ports beneath.

  6. Unscrew the 2 screws next to the USB and AC ports.
    • Unscrew the 2 screws next to the USB and AC ports.

  7. Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.
    • Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.

  8. Pull off the faceplate to reveal the inside of the camera.
    • Pull off the faceplate to reveal the inside of the camera.

    • Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

まとめ

To reassemble your device, follow these instructions in reverse order.

Katie

メンバー登録日: 2010年04月15日

25 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 28-23, Regan Spring 2010 Cal Poly, Team 28-23, Regan Spring 2010人のメンバー

CPSU-REGAN-S10S28G23

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

今までの合計 1,503