ORFELD EV-660-S222 Brush Roller Attachment LED Board Replacement

はじめに

If the LEDs in your ORFELD EV-600's brush roller attachment have gone out, this guide will show you how to replace them. The LEDs in the brush roller are a useful tool for seeing while vacuuming dark spaces. Please use caution when using a soldering iron.

必要な工具と部品

手順1 Roller Brush

ORFELD EV-660-S222 Brush Roller Attachment LED Board Replacement, Roller Brush: 手順 1、 1の画像 1

Place the roller attachment bottom side up so you may access the brush.
Apply pressure with the iFixit opening tool to the tabbed side of the orange cap to release the roller brush.

編集

手順2

Pull the roller brush from its socket one side at a time to remove it.

編集

手順3 Brush Roller Attachment LED Board

ORFELD EV-660-S222 Brush Roller Attachment LED Board Replacement, Brush Roller Attachment LED Board: 手順 3、 2の画像 1

ORFELD EV-660-S222 Brush Roller Attachment LED Board Replacement, Brush Roller Attachment LED Board: 手順 3、 2の画像 2

Remove the 11.5 mm screws surrounding the roller brush divot using a Phillips #0 screwdriver.
Remove the 11.5 mm screws located by the wheels using a Phillips #1 screwdriver.

編集

手順4

Use the iFixit opening tool to pry the attachment open to pull the top free with your hands.

編集

手順5

ORFELD EV-660-S222 Brush Roller Attachment LED Board Replacement: 手順 5、 3の画像 3

この手順で使用する道具：

Tweezers

$4.99

購入する

Pull the LED strip out with your hands or tweezers as there is a small hole at the top of the strip.

編集

手順6

Use a soldering iron to remove the wires.
Please take proper precautions during soldering and hold the wires you are soldering with tweezers.
To solder the new board, make sure the red wire is on the LED side and the black one is on the side without LEDs.

編集

手順7

Gently insert the new board. Make sure the LEDs line up with the little squares on the front of the roller brush. If it does not insert properly on the first try, keep adjusting.

編集