はじめに

The motherboard is the central control circuitry of the Nook HD and is directly connected to many of the other internal components. While repairing a broken motherboard is beyond the scope of this guide, removing and replacing the motherboard is very doable.

Be sure the device is powered off. Clean the device to prevent any dirt and dust from entering into the device.
  • Be sure the device is powered off. Clean the device to prevent any dirt and dust from entering into the device.

  • Use the plastic opening tool to gently pry the plastic screen frame away from the screen. Run the plastic opening tool along the interior edge of the screen until the screen frame is completely separated from the glass.

  • The screen frame is held onto the Nook by a set of tab that run around the outside of the frame. There may also be a line of rubber cement around the Nook under the screen frame. If your Nook has this, you will have to dig deep to separate the frame from the Nook.

This is by far the hardest step, if your Nook is like mine. There was a line of rubber cement around the Nook under the cover. If you have trouble removing the cover, do not be afraid to dig deep with your plastic prying tool. BTW, do not try this without the plastic prying tool!

David Gauntt - 返信

Use a T5 screwdriver to remove the seventeen 5.0 millimeter screws from the back casing.
  • Use a T5 screwdriver to remove the seventeen 5.0 millimeter screws from the back casing.

コメントを追加する

  • Slowly pull the back casing away from the screen and motherboard.

  • There is a cable attaching the battery in the back plate to the motherboard. Avoid detaching either end of the cable during this step.

コメントを追加する

  • Use the plastic opening tool to gently unclip the wire from the pins by pulling the white connector up.

コメントを追加する

  • There are three ribbon cable connections that you must disconnect in order to remove the motherboard.

  • The first of these connections is small black - grey plastic connection housing.

  • Use the plastic opening tool to pull the black part of the ribbon cable housing up and away from the circuit board.

  • Carefully pull the ribbon cable out of the plastic connection housing.

コメントを追加する

  • The second of these connections is a small white - tan plastic connection housing.

  • Use the plastic opening tool to pull the tan part of the housing up and away from the circuit board.

  • Carefully pull the ribbon cable out of the plastic connection housing.

コメントを追加する

  • The final connection is a large orange ribbon cable that connects to an entirely separate circuit board.

  • Use the plastic opening tool to gently pry the cable away from the smaller circuit board as to disconnect the cable from the pins.

  • Carefully pull the ribbon cable out of the plastic connection housing.

コメントを追加する

  • Use the T5 torx screwdriver to remove the four 2.5 millimeter screws that attach the motherboard to the back plate.

コメントを追加する

  • Gently pull the motherboard straight off of the back plate.

ok so then how do we fix it?

Austin Schaaf - 返信

まとめ

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

Gregory Irwin

メンバー登録日: 2014年04月15日

808 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 3-43, Maness Spring 2014 Cal Poly, Team 3-43, Maness Spring 2014人のメンバー

CPSU-MANESS-S14S3G43

5 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 9

今までの合計 2,030