メインコンテンツにスキップ

はじめに

Removing these panels allows further access to the GameCube's components.

パーツ

パーツは指定されていません。

  1. Turn over the Gamecube so that the bottom side is facing up. Locate the four screws (circled in red) on each corner of the device. Then, use a 4.5 mm Gamebit screwdriver to remove all four screws. Locate the four screws (circled in red) on each corner of the device. Then, use a 4.5 mm Gamebit screwdriver to remove all four screws.
    • Turn over the Gamecube so that the bottom side is facing up.

    • Locate the four screws (circled in red) on each corner of the device. Then, use a 4.5 mm Gamebit screwdriver to remove all four screws.

  2. With the bottom side of the GameCube facing upward and the screws removed, carefully pull the outer shell of the unit away from the top half. Then place the inside of the unit facing up. With the bottom side of the GameCube facing upward and the screws removed, carefully pull the outer shell of the unit away from the top half. Then place the inside of the unit facing up. With the bottom side of the GameCube facing upward and the screws removed, carefully pull the outer shell of the unit away from the top half. Then place the inside of the unit facing up.
    • With the bottom side of the GameCube facing upward and the screws removed, carefully pull the outer shell of the unit away from the top half. Then place the inside of the unit facing up.

  3. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  4. Gently press down on the clips located on either side of the the back panel, as shown, and carefully remove it from the main part of the device.
    • Gently press down on the clips located on either side of the the back panel, as shown, and carefully remove it from the main part of the device.

  5. With the back panel removed, carefully unclip the controller ports at the front of the unit.
    • With the back panel removed, carefully unclip the controller ports at the front of the unit.

    • A ribbon cable (outlined in yellow) is still attached to the unit. Do not disconnect this cable.

    • Controller ports are where the controllers plug into the game console, and are a half circular shape.

  6. Use a Phillips screwdriver to remove the two 2 screws(circled in red) that are located on the back of the control port. Carefully separate the gray outer casing of the control port and the circuit board.
    • Use a Phillips screwdriver to remove the two 2 screws(circled in red) that are located on the back of the control port.

    • Carefully separate the gray outer casing of the control port and the circuit board.

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

dcarlin

メンバー登録日: 2009年11月05日

199 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 6-2, Maness Fall 2009 Cal Poly, Team 6-2, Maness Fall 2009人のメンバー

CPSU-MANESS-F09S6G2

4 メンバー

8のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 14

過去 30 日: 53

今までの合計 7,466