はじめに

The circuit board connects all the components within the controller and provides structural support for buttons, sticks, and chips.

パーツ

パーツは必要ありません。

Place the controller (buttons down) on a solid surface.
  • Place the controller (buttons down) on a solid surface.

  • Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.

コメントを追加する

Gently lift the back panel up, separating it from the front panel.
  • Gently lift the back panel up, separating it from the front panel.

  • Some of the buttons may fall out if they are knocked around.

コメントを追加する

Grab the Z-button by the peg with tweezers and lift it out of the controller. During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.
  • Grab the Z-button by the peg with tweezers and lift it out of the controller.

  • During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.

コメントを追加する

Carefully unhook the cable that is looped around the peg.
  • Carefully unhook the cable that is looped around the peg.

Um can soneone explain the peg and cable part? I dont understand it...

Tyler Goamez - 返信

I would say that the cable is somehow "hooked" to the case and you have to get the cable away from the case so that you can pull out the board

My1 -

Lift the circuit board out of the controller.
  • Lift the circuit board out of the controller.

    • Do not grab the rumble motor to lift the circuit board as shown in the picture. It will in many cases just remove the rumble motor. Instead, grab the edges of the board.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Sean Michel

メンバー登録日: 2013年01月14日

1,208 ポイント

14のガイドは作成済み

チーム

Cal Poly, Team 19-44, Regan Winter 2013 Cal Poly, Team 19-44, Regan Winter 2013人のメンバー

CPSU-REGAN-W13S19G44

4 メンバー

16のガイドは作成済み

this $@$* only shows how to disassemble the controller, this isnt a guide to even get the circuid board off the cable &&^&^$^ useless pieces of $@$* lmao

jmride - 返信

Yeah this isn't very in-depth, I was hoping for a little more. I need to desolder and rewire the buttons to use for another project and I was hoping this might be a nice guide to help me do that... it's not.

Joshua Arcari - 返信

コメントを追加する

統計データを表示:

過去 24時間: 2

過去 7 日: 27

過去 30 日: 105

今までの合計 7,801