はじめに

The back cover is the only layer between the motherboard and the many things things that can ruin the motherboard. Expect the six screws that hold the cover to the device to be fastened tightly.

  1. Use a standard Phillips #00 screwdriver to loosen the 4mm screw that keeps the battery cover attached to the device.
    • Use a standard Phillips #00 screwdriver to loosen the 4mm screw that keeps the battery cover attached to the device.

    コメントを追加する

  2. Lift the battery cover up and remove it from the device.
    • Lift the battery cover up and remove it from the device.

    • The screw will remain attached to the battery cover because of Nintendo's design.

    コメントを追加する

    • Use your fingers or a plastic opening tool to remove the battery from the device.

    コメントを追加する

    • Using the tri-wing screwdriver, unscrew the screws holding the back cover to the device. The six screws that need to be removed include:

      • Four #00 6.45mm tri-wing screws that are located at the corners of the device.

      • Two #00 4.6mm tri-wing screws that are located at the top-center and bottom-center of the device.

    コメントを追加する

    • Lift the back cover off of the device.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

14 の人々がこのガイドを完成させました。

Rocco Lattanzio

メンバー登録日: 2013年01月11日

607 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 17-22, Forte Winter 2013 Cal Poly, Team 17-22, Forte Winter 2013人のメンバー

CPSU-FORTE-W13S17G22

4 メンバー

16のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 2

過去 7 日: 19

過去 30 日: 109

今までの合計 13,177