修理を始めるには コミュニティ ストア

Ninja Professional Blender BL660 Blender Base Replacement

はじめに

This guide will show how to remove the outer and inner blender base and sections from your Ninja Professional Blender BL660 Blender. This will allow you to get access to the inner components.

必要な工具と部品

  1. Ninja Professional Blender BL660 Blender Base Replacement, Blender Base: 手順 1、 2の画像 1 Ninja Professional Blender BL660 Blender Base Replacement, Blender Base: 手順 1、 2の画像 2

    • Using the Phillips #1 screwdriver, remove the 5 screws (13mm long, 6mm wide) holding the outer base.

    • Lift the base up to remove it.

    編集

  2. Ninja Professional Blender BL660 Blender Base Replacement: 手順 2、 2の画像 1 Ninja Professional Blender BL660 Blender Base Replacement: 手順 2、 2の画像 2

    • Remove the midsection by pulling it up. If the section is stuck, use the iFixit plastic opening tool to pry it off.

    • Pull the power cord through the mid-section opening.

    編集

  4. Ninja Professional Blender BL660 Blender Base Replacement: 手順 3、 2の画像 1 Ninja Professional Blender BL660 Blender Base Replacement: 手順 3、 2の画像 2

    • Using the Phillips #1 screwdriver, remove the 6 screws (13 mm long, 6 mm wide).

    編集

  5. Ninja Professional Blender BL660 Blender Base Replacement: 手順 4、 2の画像 1 Ninja Professional Blender BL660 Blender Base Replacement: 手順 4、 2の画像 2

    • Using the Phillips #1 screwdriver, remove the two screws (5 mm long, 3 mm wide) holding the power cord onto the motor cover.

    編集

  6. Ninja Professional Blender BL660 Blender Base Replacement: 手順 5、 2の画像 1 Ninja Professional Blender BL660 Blender Base Replacement: 手順 5、 2の画像 2

    • Using the iFixit plastic opening tool, pry the motor cover off the general housing. Once it is loose, lift it up to remove it off the base.

    • Slide the cover all the way to the end of the power cord.

    • Please note that the power cord does not completely come off the cover.

    編集
終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

5人の作成者と共同で作成されました。

JOHN KIMANI

メンバー登録日: 09/22/17

119 ポイント

1ガイドが承認済み

バッジ: 10

+7 個以上のバッジ

チーム

Central Washington University, Team S1-G1, Pengilly Fall 2017 Central Washington University, Team S1-G1, Pengilly Fall 2017人のメンバー

CWU-PENGILLY-F17S1G1

4 メンバー

9のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 2

過去 7 日: 17

過去 30 日: 66

今までの合計 2,767