Ninja Professional BL610 LED Replacement - iFixit 修理ガイド

はじめに

Use this guide to replace the LED on the circuit board of your device.

必要な工具と部品

手順1 LED

Ninja Professional BL610 LED Replacement, LED: 手順 1、 1の画像 1

Remove six screws (12mm long, 6mm head diameter) from bottom of the blender using a Phillips #2 screwdriver.

手順2

Ninja Professional BL610 LED Replacement: 手順 2、 1の画像 1

Remove six screws (12mm long, 6mm head diameter) from component housing using Phillips #2 screwdriver.

手順3

Ninja Professional BL610 LED Replacement: 手順 3、 1の画像 1

Remove five screws from circuit board using Phillips #2 screwdriver.

手順4

Ninja Professional BL610 LED Replacement: 手順 4、 1の画像 1

Once the screws are removed, lift the circuit board to access the back.

手順5

Ninja Professional BL610 LED Replacement: 手順 5、 1の画像 1

Locate the LED you wish to replace and note its position on the opposite side of the circuit board.

手順6

Ninja Professional BL610 LED Replacement: 手順 6、 1の画像 1

Desolder both of the LED leads and remove the LED light. Note the orientation of LED, this is important for replacing the LED. The Replacement LED needs to be soldered in the same orientation.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

1人の作成者と共同作成されました。

Rosniel Castro

メンバー登録日: 09/27/17

482 ポイント

4のガイドは作成済み

+5 個以上のバッジ

チーム

USF Tampa, Team S14-G3, Boczar Fall 2017 USF Tampa, Team S14-G3, Boczar Fall 2017人のメンバー

USFT-BOCZAR-F17S14G3

4 メンバー

4のガイドは作成済み

0 件のコメント

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 4

今までの合計 140