はじめに

If there is a power problem, you may need to reattach wires to the battery compartment or replace it completely. If the problem is Corrosion, just see the guide on corrosion.

  • In this guide we will be referring to 'left' and 'right' as though the camera's front (the part that says Nikon) is facing you.

  • Unscrew the large metal screw on the left side using a quarter and remove the battery cover.(Picture not available)

コメントを追加する

Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.
  • Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.

コメントを追加する

Pull up on the tab to remove the batteries.
  • Pull up on the tab to remove the batteries.

  • Note: The batteries will probably fall out of their holder.

コメントを追加する

Use a 00 Phillips head screwdriver to remove the four screws from inside the case.
  • Use a 00 Phillips head screwdriver to remove the four screws from inside the case.

コメントを追加する

Remove the battery compartment from the camera.
  • Remove the battery compartment from the camera.

  • Note: On some models, the compartment is soldered in by the wires shown. If so you will need to desolder them.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Zachary Phillips

メンバー登録日: 2011年04月08日

178 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 25-26, Garner Spring 2011 Cal Poly, Team 25-26, Garner Spring 2011人のメンバー

CPSU-GARNER-S11S25G26

3 メンバー

6のガイドは作成済み

コメント1件

Hey, i lost the bracket… do u guys have any idea where could i get one?

David mate - 返信

コメントを追加する

統計データを表示:

過去 24時間: 2

過去 7 日: 28

過去 30 日: 98

今までの合計 9,060