Nikon D40 Back Cover Replacement

はじめに

This guide will demonstrate the proper procedure to remove the back panel without damaging the internals of the camera so that you can access a variety of the components hidden behind it.

必要な工具と部品

手順1 Back Cover

Nikon D40 Back Cover Replacement, Back Cover: 手順 1、 1の画像 1

Remove the two visible 6.0 mm Philips #0 screws on the left and right sides of the viewfinder. These screws are highlighted in red.

編集

手順2

Remove the four 6.0 mm Philips #0 screws on the left and right sides of the camera.

編集

手順3

Remove the four highlighted 3.0 mm Philips #0 screws on the bottom of the camera.

編集

手順4

While pulling the bottom down, remove the back of the camera.
Be careful not to pull too hard on the back as it is connected via a ribbon cable. Be sure to disconnect this cable on the main board.
To disconnect the ribbon cable pull the small black tab upward and pull gently on the cable.