難易度
普通
手順
11
所要時間
必要時間を提案??
- Back Cover 6手順
- Lens 3手順
- Motherboard 2手順
箇条書き！
マークアップやブレットの色や形を変えてコーディネートしてみるとこのガイドをより見やすくできます。
高画質の画像が必要
よりよい画像があればこのガイドが改善されます。よければ新しい写真を撮影し、編集し、アップロードしてお手伝いください。
はじめに
You will need a #00 phillip's head screwdriver and a black spudger (or equivalent tool).
パーツ
パーツは必要ありません。
-
Turn over camera to find 5 apparent screws.
-
Remove all 5 screws from the bottom of the camera and store them carefully.
-
Open battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of orange lever. Remove this screw.
-
Rotate camera to find side panel with lanyard attachment. Detach side panel by lifting bottom corner slightly with the spudger.
-
Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.
-
With back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.
-
Find the five screws on the metal plate and remove them. One of them is in a hole in the corner of the metal plate.
-
Also remove the screw at the bottom of the camera.
-
Carefully lift metal plate from the right side to reveal a ribbon connected to the motherboard.
-
Lift the white flap with the spudger to release the ribbon and remove back metal plate.
-
Lift the two ribbons with the spudger to disconnect the lens and pull it out.
-
Lift two flaps with the spudger on the top of the motherboard to release ribbons.
-
lift motherboard from the top to remove it from the camera.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
チーム
Cal Poly, Team 18-24, Garner Spring 2011 Cal Poly, Team 18-24, Garner Spring 2011人のメンバー
CPSU-GARNER-S11S18G24
4 メンバー
6のガイドは作成済み
