はじめに

Replacing the front cover of a Nikon Coolpix 3500.

パーツ

パーツは必要ありません。

Unlatch the battery cover. Slide the cover out and flip it open.
  • Unlatch the battery cover. Slide the cover out and flip it open.

  • Remove the battery.

  • Gently remove the battery cover.

コメントを追加する

Remove the two 4.5 mm screws that sit next to the battery slot.
  • Remove the two 4.5 mm screws that sit next to the battery slot.

  • Remove the 3 mm screw that sits below the CF card slot.

  • Remove the 4.5 mm screw that sits above the digital I/O cover.

コメントを追加する

  • Remove the two 4.5 mm screws that sit inside the battery slot.

コメントを追加する

  • Remove the two 5 mm screws that sit near the camera strap eyelet.

  • Remove the camera strap eyelet.

コメントを追加する

  • Remove the 5 mm screw and cap that were underneath the camera strap eyelet.

コメントを追加する

  • Remove the five 3.5 mm screws that sit at the bottom of the camera.

  • Remove the grey plastic piece, which the five screws held in place, by gently detaching the front cover.

  • Do not apply too much force; two wires still connect the front cover to the logic board.

コメントを追加する

  • Using a spudger, detach the white-capped wire.

  • Using a spudger, detach the orange-capped wire and set the front cover aside.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

richard guenther

メンバー登録日: 2010年04月19日

183 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 30-38, Garner Spring 2010 Cal Poly, Team 30-38, Garner Spring 2010人のメンバー

CPSU-GARNER-S10S30G38

5 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 1,691