はじめに

Replacing the logic board of a Nikon Coolpix 3500

パーツ

パーツは必要ありません。

Unlatch the battery cover. Slide the cover out and flip it open.
  • Unlatch the battery cover. Slide the cover out and flip it open.

  • Remove the battery.

  • Gently remove the battery cover.

コメントを追加する

Remove the two 4.5 mm screws that sit next to the battery slot.
  • Remove the two 4.5 mm screws that sit next to the battery slot.

  • Remove the 3 mm screw that sits below the CF card slot.

  • Remove the 4.5 mm screw that sits above the digital I/O cover.

コメントを追加する

  • Remove the two 4.5 mm screws that sit inside the battery slot.

コメントを追加する

  • Remove the two 5 mm screws that sit near the camera strap eyelet.

  • Remove the camera strap eyelet.

コメントを追加する

  • Remove the 5 mm screw and cap that were underneath the camera strap eyelet.

コメントを追加する

  • Remove the five 3.5 mm screws that sit at the bottom of the camera.

  • Remove the grey plastic piece, which the five screws held in place, by gently detaching the front cover.

  • Do not apply too much force; two wires still connect the front cover to the logic board.

コメントを追加する

  • Using a spudger, detach the white-capped wire.

  • Using a spudger, detach the orange-capped wire and set the front cover aside.

コメントを追加する

  • Detach the grey-capped wire.

  • Detach the green chip that sits next to the blue wires.

コメントを追加する

  • Remove the 3.5 mm screw that sits next to the rotating lens.

  • Invert the logic board and lens to uncover the orange and blue ribbon cables. These cables still connect the logic board to the LCD screen.

コメントを追加する

  • Detach the blue ribbon cable.

  • Detach the orange ribbon cable by using a spudger, and while pushing it out horizontally.

  • Detach the red-capped wire.

  • Lift the logic board and lens, which are still connected, out of the back cover.

コメントを追加する

  • Lift the black covering and remove the orange ribbon cable, which connects the lens to the logic board.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

richard guenther

メンバー登録日: 2010年04月19日

183 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 30-38, Garner Spring 2010 Cal Poly, Team 30-38, Garner Spring 2010人のメンバー

CPSU-GARNER-S10S30G38

5 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 3

過去 30 日: 3

今までの合計 1,874