はじめに

This guide is to be used to install the wrist strap holder in the case that the holder becomes damaged or no longer functioning properly due to overuse. A Phillips screwdriver will be needed to complete this installation.

パーツ

パーツは必要ありません。

Remove the wrist strap from the wrist strap holder by untying the string at the end of the wrist strap.
  • Remove the wrist strap from the wrist strap holder by untying the string at the end of the wrist strap.

    • This will allow for the wrist strap to be pulled through the wrist strap holder.

コメントを追加する

Using the thumb, firmly push the Battery/SD cover in the middle and in the direction of the arrow on the Battery/SD cover.
  • Using the thumb, firmly push the Battery/SD cover in the middle and in the direction of the arrow on the Battery/SD cover.

    • This will cause the Battery/SD cover to pop open.

コメントを追加する

Use the Phillips screwdriver to remove the four screws on the bottom of the camera.
  • Use the Phillips screwdriver to remove the four screws on the bottom of the camera.

コメントを追加する

Using fingers, pull the silver side panels from each side.
  • Using fingers, pull the silver side panels from each side.

コメントを追加する

On the right hand side of the camera, remove the two screws from the wrist strap handle by using the Phillips screwdriver.
  • On the right hand side of the camera, remove the two screws from the wrist strap handle by using the Phillips screwdriver.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Patty Richeson

メンバー登録日: 2013年03月11日

75 ポイント

4のガイドは作成済み

チーム

Clemson, Team 12-5, Benson Spring 2013 Clemson, Team 12-5, Benson Spring 2013人のメンバー

CLEM-BENSON-S13S12G5

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 423