はじめに

installing the front speaker

Using two fingers, push up on the rear cover.
  • Using two fingers, push up on the rear cover.

コメントを追加する

The rear cover slides up and off.
  • The rear cover slides up and off.

コメントを追加する

  • Using the plastic opening tools, pry the left bottom corner of the battery up.

コメントを追加する

  • Pull the battery up and out.

コメントを追加する

  • Remove the two Torx T5 screws.

  • Remove the one Philips #00 screw.

#0 Phillis screw

skuhry - 返信

  • Using the plastic opening tool, pry up the battery housing upwards.

  • Push pry tool down, undoing the plastic tab.

コメントを追加する

  • Pry the upper left tab open on the battery housing.

コメントを追加する

  • Pry the top tab of the battery housing.

コメントを追加する

  • Pry the right side tab of the battery housing.

コメントを追加する

  • Pull up on the battery housing.

  • Slide the battery housing out to remove it.

コメントを追加する

  • Insert the spudger under the connector.

  • Push the spudger up and twist to release the connector.

  • Repeat for the next connector.

コメントを追加する

  • Push on the USB port to expose the black connector.

  • Use the spudger to pry the connector upwards.

The philips screw holding down the logic board (at the lower right corner in the picture) has to be removed before the board can be pushed back.

Mark - 返信

  • Place the spugder under the antenna connector.

  • Pry connector up vertically.

コメントを追加する

  • Insert the spudger into tab above the camera.

  • Slide upwards until the board detaches from the case.

A philips screw holding down the upper logic board (in the lower left corner of the picture) must be remobed before the board can be detached.

Mark - 返信

  • Press the pointed tip of the spudger into the space below the button assembly.

  • Wiggle the spudger tip towards the outside of the button.

  • The button assembly is under some tension and may fly off.

コメントを追加する

  • Push the pointed tip of the spudger into the base of the side button board.

  • Lift up, the board will disconnect from the case.

コメントを追加する

  • Push on the lower motherboard until it slides under the case support.

  • The motherboard assembly comes out as a single piece.

  • Save the small black rubber rectangular sound guide under the motherboard, to replace over the microphone.

Be carefull not to tear the home button cable that is in the top right corner!!

zack - 返信

  • Using the spudger, pop up the end of the speaker.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Niklas Johnson

メンバー登録日: 2012年01月31日

1,063 ポイント

18のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 2,199