はじめに

Use this guide to replace the backplate that secures the motherboard of your Nexus 5.

Use a plastic opening tool to free the clips on the top and each side of the back cover. The bottom is secured with some adhesive foam. You should be able to finally free the back cover using an opening pick. It's best to avoid prying around the SIM card slot, as the plastic here is very thin and likely to break from prying.
  • Use a plastic opening tool to free the clips on the top and each side of the back cover.

  • The bottom is secured with some adhesive foam. You should be able to finally free the back cover using an opening pick.

  • It's best to avoid prying around the SIM card slot, as the plastic here is very thin and likely to break from prying.

Wireless QI and NFC.

Once I have put everything together with the new battery in place, I have as last replaced the plastic back cover, snapping all the clips back around the edges of the phone. Alas, I was quick to realise the QI Wireless charging has ceased to work.

I almost blamed the battery, or worse, me.

QUICK TIP: there is actually another clip in the middle of the plastic back cover - just press with your thumb just above the 'S' in NEXUS emblem and, voila! Snaps back in.

Wireless charge and NFC - works, once again.

cwioro - 返信

you just saved me like 30 bucks. thank you so much.

Robert Nolan -

+ 1, had the same issue and pressing just near the S fixed it! Thanks a lot!

nicco82 -

Just a me too, I had to press above the S and it was quite a snap

Erik Karlin -

There seems to be two contacts that snap into place. One is in line with the led pretty much in the middle of the phone and the second one in line with the camera lens on the opposite side to the lens. The middle one for me snapped pretty lightly, but the side one required a bit more pressure. After that the nfc started working again. Thanks for posting this!

Dennis Millner -

Is it hard to remove the battery door? Worried I might damage it.

Ash - 返信

When I openend the back cover I damaged two clips. One about 2.5cm (1 inch) below the volume controls and one on the other side about same height. The cover fits good without those two but on one side there is a small gap where the clip broke. But I have a hard cover protector on my phone so it's not that bad.

simonlwheeler - 返信

The case around the sim slot is pretty thin and easy to break, best to avoid using the pry tool at this point.

Aled Morris - 返信

Excellent tip, should be included in the main guide.

fprades - 返信

Hey Author, i need to ur expert advice...i replaced my nexus 5's back cover. since the new one did not have the vibrators battery i had to take it from the old one and connect it to the new one...on removing i noticed that it was stuck to the cover by a glue

Question: what glue to use to hold the battery to the cover?

suwaid akbar - 返信

Any adhesive will do. I used a hot glue gun. You shouldn't need expert advice to figure that out. Use your head.

tjt263 -

The case around the volume control is also pretty thin.... I broke mine prying so avoid the pry there too.

Also my back had glue at the bottom and I haven't seen mentioned

kornerson - 返信

Remove the six 4.0 mm Phillips #00  screws that secure the midframe to the phone.
  • Remove the six 4.0 mm Phillips #00 screws that secure the midframe to the phone.

  • To replace the LCD screen and digitizer, remove the additional four 4.0mm daughterboard cover screws with the same screwdriver.

I had a bit more success with the Phillips #000.

Ross Light - 返信

Step 4 (removing the screws in the protecting plate) needs to happen before Step 2 ( removing the connectors)

Esteban Valles - 返信

These were Y0 screws for me.

Benjamin Hollway - 返信

Same here, Benjamin

Ítalo Masserano -

Same for me. I had more luck with the two screws in the middle with #000.

Rewarp - 返信

Remove the midframe from the phone. Remove the midframe from the phone.
  • Remove the midframe from the phone.

There's also some adhesive holding the motherboard cover plate in place, below the camera. Has to be pulled a little stronger than expected.

tkatona - 返信

まとめ

To reassemble your device, follow these instructions in reverse order.

16 の人々がこのガイドを完成させました。

Gaetan

メンバー登録日: 2012年12月26日

9,276 ポイント

30のガイドは作成済み

Bonjour est ce que le remplacement de la vitre de la caméra uniquement est possible? Comment est ce fixé sur le midframe ?

Merci

Multinet - 返信

Excellent guide. One caution not noted here, I accidentally turned the phone back on while working on getting the midframe out. Be careful to not touch the on/off switch on the side.

gantgrg - 返信

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 12

過去 30 日: 67

今までの合計 18,632