Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement

はじめに

This guide will show you how to replace the springs in a Nerf N-Strike Elite Rough Cut 2x4 gun. Nerf guns use springs to power their guns. However, over time, these springs lose power and thus the gun cannot shoot as far or as powerfully. When this happens, the gun can simply not be effective for Nerf fights. However instead of buying a new gun and throwing away the old one you can simply add new springs and get the same if not better performance.

必要な工具と部品

手順1 Springs

Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement, Springs: 手順 1、 2の画像 1

Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement, Springs: 手順 1、 2の画像 2

Remove three screws with a Phillips #1 screwdriver.
Remove the pump grip.

編集

手順2

Remove thirteen highlighted screws using a Phillips #1 screwdriver.
The top rail has shorter screws than the rest.
Some of these are captive screws and cannot be removed.

編集

手順3

Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement: 手順 3、 3の画像 3

Remove the backside by sliding the plastic spudger across the seam.
There are loose parts that can fall out. Take these off and put them aside.

編集

手順4

Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement: 手順 4、 3の画像 3

Separate the trigger mechanism from the barrel.

編集

手順5

Nerf N-Strike Elite Rough Cut 2x4 Springs Replacement: 手順 5、 3の画像 3

Remove the plunger springs from the mechanism by pulling one of the springs back then bending it off the connection.
These are tricky to remove, so be careful when pulling them off.

編集