Motorola Xoom 2 Rear-Facing Camera Replacement

はじめに

Overtime, the camera of a device may be subject to fail. Common troubleshooting symptoms of a failing camera can include (and are not limited to): device isn’t taking photos, camera shows black, camera won’t turn on, etc.

This replacement guide demonstrates the steps required to replace a cracked, damaged, or otherwise inoperable rear-facing camera on the Xoom 2.

必要な工具と部品

手順1 Backplate

Motorola Xoom 2 Rear-Facing Camera Replacement, Backplate: 手順 1、 3の画像 1

Motorola Xoom 2 Rear-Facing Camera Replacement, Backplate: 手順 1、 3の画像 2

Motorola Xoom 2 Rear-Facing Camera Replacement, Backplate: 手順 1、 3の画像 3

Pry off the silver top back cover (the panel around the camera) with iFixit opening picks or a similar implement.

編集

手順2

Using a T5 screwdriver, unscrew the four 1.5mm screws holding the main back cover. These screws are arranged in a line across the top of the back of the device.

編集

手順3

Motorola Xoom 2 Rear-Facing Camera Replacement: 手順 3、 3の画像 3

Turn the device over and using a pry tool and the opening picks, gently apply pressure between the outside edge of the seal marked with the arrow. Slowly move around the edges of the device, applying even pressure, and separate the back plate from the display.
There is adhesive between the back-plate and battery.

編集

手順4

Remove the back plate from your device.

編集

手順5 Rear-Facing Camera

Motorola Xoom 2 Rear-Facing Camera Replacement, Rear-Facing Camera: 手順 5、 1の画像 1

この手順で使用する道具：

Tweezers

$4.99

購入する

Using tweezers, remove the blue Kapton tape.
Set this piece aside as it is required for reassembly.

編集

手順6

Using a spudger, carefully pry and remove camera assembly using the small pry point as shown.
After removing the camera from the housing, use tweezers and pull gently to remove the connector from its housing.

編集