はじめに

This guide describes how to replace the button key board, or the processor that interprets key pad information.

Remove battery cover by pushing down release lever at top of phone while prying off cover.
  • Remove battery cover by pushing down release lever at top of phone while prying off cover.

  • Set cover aside.

コメントを追加する

Remove battery by grabbing it near the bottom and lifting out.
  • Remove battery by grabbing it near the bottom and lifting out.

コメントを追加する

  • Unscrew four corner screws with T6 screwdriver.

    • Note: The two top screws are short and silver. The two bottom screws are black and long.

コメントを追加する

  • Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.

コメントを追加する

  • Starting from left side of phone, remove side buttons and place aside.

    • Note: There should be three buttons. One on each side, and the top.

  • Return phone to starting orientation when done.

コメントを追加する

  • Gently remove orange ribbon cable by prying up with spudger.

コメントを追加する

  • Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting.

    • Note: Orange ribbon cable is fragile and can be broken.

コメントを追加する

  • Insert spudger under button board and gently lift, set aside.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Eric Freeman

メンバー登録日: 2010年01月26日

1 ポイント

7のガイドは作成済み

チーム

Cal Poly, Team 8-48, Regan Winter 2010 Cal Poly, Team 8-48, Regan Winter 2010人のメンバー

CPSU-REGAN-W10S8G48

4 メンバー

13のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,278