難易度
普通
手順
7
所要時間
25分
- Screen 6手順
- Earpiece Speaker 手順1
文法の修正
あなたの中にある日本語能力を呼び起こし、このガイドの文法に磨きをかけましょう。
間違いの指摘
このガイドは最適な校正が必要です。校正の注釈を付けたり訂正することにご協力ください。
はじめに
This guide is for removing the phone's earpiece speaker.
パーツ
パーツは必要ありません。
-
Using a spudger, remove the four rubber covers from over the screws.
-
Unscrew the cover screws using the T6 bit
-
Loosen and remove the cover with a plastic opening tool.
-
Gently loosen the protective cover with the plastic opening tool.
Do not pry from the top or bottom of the metal cover. There are a pair of 1/4" long openings on either side of the metal cover at the midpoint of the case. The plastic teeth which lock into the openings must be withdrawn. I used the point of cuticle sissors to get behind the metal strip under each tooth and pull outwards a small distance to release each tooth. The sides of the cover will spring up.
-
Slowly peel the black rubber gasket up off the circuit board.
-
Carefully move the camera out of the way using your hand.
-
Use a flat tool to separate the connection between the upper and lower circuit boards.
-
Gently slip the copper strip out from under the circutry by hand.
-
Pry out the speaker using your fingers.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
チーム
Cal Poly, Team 6-6, Maness Fall 2009 Cal Poly, Team 6-6, Maness Fall 2009人のメンバー
CPSU-MANESS-F09S6G6
4 メンバー
12のガイドは作成済み
