メインコンテンツにスキップ

はじめに

This guide is used for taking apart and/or replacing the circuit board of the phone.

パーツ

パーツは指定されていません。

  1. Push down on the chrome button at the bottom of the back of the phone. Slide the outer casing down to reveal the battery Push down on the chrome button at the bottom of the back of the phone. Slide the outer casing down to reveal the battery
    • Push down on the chrome button at the bottom of the back of the phone. Slide the outer casing down to reveal the battery

  2. Apply pressure to the bottom corners of the battery, and then push upwards to lever the battery out.
    • Apply pressure to the bottom corners of the battery, and then push upwards to lever the battery out.

  3. Remove the rubber screw covers using a plastic spudger. Use a T-6 screw bit to remove the screws. Use a T-6 screw bit to remove the screws.
    • Remove the rubber screw covers using a plastic spudger.

    • Use a T-6 screw bit to remove the screws.

  4. Unscrew the antenna.
    • Unscrew the antenna.

  5. Use a plastic opening tool to undo the latches at the indicated spots. Dental tools may be used in place of a plastic opening tool, as they are difficult to use. Warning: exercise caution as the plastic can break.
    • Use a plastic opening tool to undo the latches at the indicated spots.

    • Dental tools may be used in place of a plastic opening tool, as they are difficult to use.

    • Warning: exercise caution as the plastic can break.

  6. Remove the circuit board connection (copper flap) by first loosening it with a plastic opening tool. Lift the connection up with your finger.
    • Remove the circuit board connection (copper flap) by first loosening it with a plastic opening tool.

    • Lift the connection up with your finger.

  7. Use your finger to remove the pressure pad from the buttons on the side of the casing. Remove the plastic flap from around the buttons by lifting it up and pulling it out. Gently lift the logic board up.
    • Use your finger to remove the pressure pad from the buttons on the side of the casing.

    • Remove the plastic flap from around the buttons by lifting it up and pulling it out.

    • Gently lift the logic board up.

終わりに

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

gregatron

メンバー登録日: 2009年10月29日

105 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 6-6, Maness Fall 2009 Cal Poly, Team 6-6, Maness Fall 2009人のメンバー

CPSU-MANESS-F09S6G6

4 メンバー

12のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 2

今までの合計 2,996