はじめに

Replacing the screen and connector ribbon.

パーツ

パーツは必要ありません。

Pull at top of faceplate, and it will pop off.
  • Pull at top of faceplate, and it will pop off.

コメントを追加する

Unscrew four screws on front cover.
  • Unscrew four screws on front cover.

コメントを追加する

Slide out metallic silver cover.
  • Slide out metallic silver cover.

  • This piece is wedged in tight. Try to slide out one hook at a time, instead of both simultaneously.

コメントを追加する

Use a tool to wedge in between the silver and black parts on the cover.
  • Use a tool to wedge in between the silver and black parts on the cover.

  • Silver part should now snap off.

コメントを追加する

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Black rubber part may now be easily removed.
  • Black rubber part may now be easily removed.

コメントを追加する

Use a soldering iron to disconnect the connector ribbon from the phone.
  • Use a soldering iron to disconnect the connector ribbon from the phone.

コメントを追加する

Locate the four screws on the back of the phone. Using your T6 Torx Screwdriver, unscrew these screws. Remove the SIM card located on the back of the phone.
  • Locate the four screws on the back of the phone.

  • Using your T6 Torx Screwdriver, unscrew these screws.

  • Remove the SIM card located on the back of the phone.

  • A ribbon near the antenna is still attached to the motherboard. Do not break this ribbon.

コメントを追加する

Unclip the pronged rectangle connector ribbon attached to the motherboard. Remove the motherboard.
  • Unclip the pronged rectangle connector ribbon attached to the motherboard.

  • Remove the motherboard.

コメントを追加する

Now that the ribbon is loose, the screen (white part) can swing away. Some of the black "tape" can be peeled back, but the screen is still attached.  More work may be required to fully separate this part.
  • Now that the ribbon is loose, the screen (white part) can swing away.

  • Some of the black "tape" can be peeled back, but the screen is still attached. More work may be required to fully separate this part.

コメントを追加する

Slide out the part of the connector ribbon that was just attached to the motherboard through this narrow slot in the phone. This is a tight fit.  Be careful to not tear the ribbon while maneuvering it through this slot.
  • Slide out the part of the connector ribbon that was just attached to the motherboard through this narrow slot in the phone.

  • This is a tight fit. Be careful to not tear the ribbon while maneuvering it through this slot.

  • The entire connector ribbon unit can now be removed from the phone.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Tyler Knisley

メンバー登録日: 2010年05月07日

1 ポイント

14のガイドは作成済み

チーム

Cal Poly, Team 6-16, Maness Spring 2010 Cal Poly, Team 6-16, Maness Spring 2010人のメンバー

CPSU-MANESS-S10S6G16

4 メンバー

14のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 3,132