Motorola Talkabout FV700R Front Faceplate Replacement

作成者： Jack Harrison (そして 3 人のその他投稿者)

コメント: 0
お気に入り: 1

Motorola Talkabout FV700R Front Faceplate Replacement

難易度

普通

手順

所要時間

5 - 15 分

はじめに

The front faceplate protects the components inside the radio. To replace inside components, the front faceplate of the radio must be removed. Follow the steps below to properly open the radio.

ツール

これらのツールを購入する

パーツ

パーツは指定されていません。

手順1 Battery

Remove the back battery cover by pressing the tab to the left, and lifting.

Remove the back battery cover by pressing the tab to the left, and lifting.
A small screwdriver can aid this process.

編集

手順2

Remove the batteries currently in the radio.

Remove the batteries currently in the radio.
When you're ready to add new batteries, place Ni-MH or AAA replacement batteries in the specified slots.
The orientation of the batteries is specified in the battery compartment.

編集

手順3 Volume Knob

Turn the Volume knob to the off position.

Turn the Volume knob to the off position.

編集

手順4

Firmly grasp and pull back on the volume knob. The knob should come off smoothly.

This may require some twisting and force.

Firmly grasp and pull back on the volume knob. The knob should come off smoothly.
This may require some twisting and force.

編集

手順5 Front Faceplate

Remove the four 3 millimeter T6 Torx screws from the front of the radio.

Remove the four 3 millimeter T6 Torx screws from the front of the radio.

編集

手順6

Remove the four 3 millimeter T8 Torx screws from the back of the radio.

Remove the four 3 millimeter T8 Torx screws from the back of the radio.

編集

手順7

Gently open the backplate of the radio. Use a flathead screwdriver to slowly pry apart the two sides.

Be careful, as the antenna is still attached. Pulling the two sides apart too quickly could break the antenna.

Gently open the backplate of the radio. Use a flathead screwdriver to slowly pry apart the two sides.
Be careful, as the antenna is still attached. Pulling the two sides apart too quickly could break the antenna.

編集

手順8

Gently pull the circuit board away from the front faceplate.

Be careful not to tug the wire connecting the circuit board to the speaker, as it is still attached to the faceplate.

Gently pull the circuit board away from the front faceplate.
Be careful not to tug the wire connecting the circuit board to the speaker, as it is still attached to the faceplate.
Do not touch the the button contacts on the circuit board (the button contacts are shown in the red box of the second picture). This can cause long-term damage to the radio unless you properly clean them (see Repairing Motorola TALKABOUT FV700 Two Way Radio Button Contacts Guide).