はじめに

In this guide, you will be installing the speaker that is on the bottom of the phone. This speaker is used to make speaker phone calls, play ringtones, and other phone sounds.

パーツ

パーツは必要ありません。

  1. Remove the back cover by pressing down the silver button. Pull the cover away from the phone.
    • Remove the back cover by pressing down the silver button.

    • Pull the cover away from the phone.

  2. Remove the battery by pushing down on the top and pulling it away from the phone, similar to the cover. Remove the battery by pushing down on the top and pulling it away from the phone, similar to the cover.
    • Remove the battery by pushing down on the top and pulling it away from the phone, similar to the cover.

  3. Remove the SIM card by pulling it toward the top of the phone with your thumb.
    • Remove the SIM card by pulling it toward the top of the phone with your thumb.

  4. Free shipping on all orders over $100.00 or containing a Pro Tech Toolkit!

    当社のショップを閲覧する

    Ever fixed something? That’s Genius.

    Share your repair story with #ImAGenius

    We Are All Geniuses

    Share your repair story with #ImAGenius

  5. Unscrew the two 5mm T6 Torx screws form the phone.
    • Unscrew the two 5mm T6 Torx screws form the phone.

  6. Pry open the back of the phone using the spudger. There are four clips, one on the left, one on the right, and two on the bottom of the phone.
    • Pry open the back of the phone using the spudger. There are four clips, one on the left, one on the right, and two on the bottom of the phone.

    • You can rotate the phone left and right to get easier access while prying.

    • Make sure to fold back of phone down (or left depending on your orientation) after separating from body as there is ribbon connecting the back to the phone's body which can be ripped if pulled the wrong way.

    • The tab as well as the plastic clips are fragile, be careful when using them.

  7. Using tweezers, disconnect the copper ribbon on the left side of the phone by pulling it up from the circuit board.
    • Using tweezers, disconnect the copper ribbon on the left side of the phone by pulling it up from the circuit board.

    • The clear part below the circuit board is the antenna.

  8. Remove the antenna by pushing in the tabs on the sides with the spudger, and pulling it out.
    • Remove the antenna by pushing in the tabs on the sides with the spudger, and pulling it out.

    • These clips are also fragile.

    • When reassembling, make sure the copper piece of the antenna is properly inserted between the two copper clips that stick up from the phone.

  9. Using the spudger, pry up the primary speaker from the phone.
    • Using the spudger, pry up the primary speaker from the phone.

    • The speaker is magnetic and might stick to the board.

まとめ

To reassemble your device, follow these instructions in reverse order.

Matthew Cristler

メンバー登録日: 2013年04月21日

122 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 3-46, Amido Spring 2013 Cal Poly, Team 3-46, Amido Spring 2013人のメンバー

CPSU-AMIDO-S13S3G46

4 メンバー

8のガイドは作成済み

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 4

今までの合計 1,600