Motorola Razr V3 LCD Screens and Call Speaker Replacement

はじめに

If your screen is damaged or has dust underneath the plastic cover, it may need to be removed. This guide provides steps to install the LCD screens and call speaker for your Motorola Razr V3.

必要な工具と部品

手順1 Battery

Motorola Razr V3 LCD Screens and Call Speaker Replacement, Battery: 手順 1、 2の画像 1

Motorola Razr V3 LCD Screens and Call Speaker Replacement, Battery: 手順 1、 2の画像 2

Remove the back cover by pressing down the silver button.
Pull the cover away from the phone.

編集

手順2

Remove the battery by pushing down on the top and pulling it away from the phone.

編集

手順3 Upper Casing

Motorola Razr V3 LCD Screens and Call Speaker Replacement, Upper Casing: 手順 3、 1の画像 1

この手順で使用する道具：

Tweezers

$4.99

購入する

Use tweezers to pry off the four rubber screw covers from the inside face.
Our phone is missing the two left screw covers, be careful not to lose yours too!

編集

手順4

Remove the four T5 Torx screws that were underneath the rubber covers.

編集

手順5

Use the plastic opening tool to pry the top cover away from the phone.
The side buttons on the phone may fall out when the top cover is separated from the phone. They can easily be put back by placing them in their original spot.

編集

手順6 LCD Screens and Call Speaker

Motorola Razr V3 LCD Screens and Call Speaker Replacement, LCD Screens and Call Speaker: 手順 6、 1の画像 1

Use the spudger to pry off the plastic lens that covers the LCD screen.
You will feel some resistance due to the adhesive put in between the screen and the plastic lens. Be careful not to damage the LCD screen.
When reassembling, put the screen lens on last. It is much easier to align the lens when you use the upper casing as a guide.

編集

手順7

この手順で使用する道具：

Tweezers

$4.99

購入する

Use the tweezers to gently pry the silver ribbon cable up towards you.
Be careful not to damage the ribbon cable when pulling it off, as it can be fragile.

編集

手順8

Use he tweezers to flip up the tab.
With the tab up, gently pull the copper ribbon cable out.
Be careful not to damage the ribbon cable when pulling it out, as it is fragile.

編集

手順9

Use the tweezers to gently fold the buttons away from the phone.
Be careful not to rip buttons off of the board. You will feel some resistance from the adhesive, but they should easily fold up if they are pulled from the bottom.
Use the spudger the speaker from the phone.

編集

手順10

Place your thumb on the screen and gently push into the phone.
It should come out pretty easy. If it is not budging go back and check over the steps again.

編集