はじめに

This guide will provide the steps to install a new antenna in your Motorola Razr V3. If you are not getting any cell signal or can not connect a call, a broken antenna may be the problem and a new one can be installed using this guide.

パーツ

パーツは必要ありません。

  1. Remove the back cover by pressing down the silver button. Pull the cover away from the phone.
    • Remove the back cover by pressing down the silver button.

    • Pull the cover away from the phone.

  2. Remove the battery by pushing down on the top and pulling it away from the phone, similar to the cover. Remove the battery by pushing down on the top and pulling it away from the phone, similar to the cover.
    • Remove the battery by pushing down on the top and pulling it away from the phone, similar to the cover.

  3. Pro Tech ツールキットを含むご注文、もしくは総額 $100ドル以上のご注文については送料無料です。

    当社のショップを閲覧する
  4. Unscrew the two 5mm T6 Torx screws form the phone.
    • Unscrew the two 5mm T6 Torx screws form the phone.

  5. Pry open the back of the phone using the spudger. There are four clips, one on the left, one on the right, and two on the bottom of the phone.
    • Pry open the back of the phone using the spudger. There are four clips, one on the left, one on the right, and two on the bottom of the phone.

    • You can rotate the phone left and right to get easier access while prying.

    • Make sure to fold back of phone down (or left depending on your orientation) after separating from body as there is ribbon connecting the back to the phone's body which can be ripped if pulled the wrong way.

    • The tab as well as the plastic clips are fragile, be careful when using them.

  6. Using tweezers, disconnect the copper ribbon on the left side of the phone by pulling it up from the circuit board.
    • Using tweezers, disconnect the copper ribbon on the left side of the phone by pulling it up from the circuit board.

    • The clear part below the circuit board is the antenna.

  7. Remove the antenna by pushing in the tabs on the sides with the spudger, and pulling it out.
    • Remove the antenna by pushing in the tabs on the sides with the spudger, and pulling it out.

    • These clips are also fragile.

    • When reassembling, make sure the copper piece of the antenna is properly inserted between the two copper clips that stick up from the phone.

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Ross Byers

メンバー登録日: 2013年04月18日

160 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 3-46, Amido Spring 2013 Cal Poly, Team 3-46, Amido Spring 2013人のメンバー

CPSU-AMIDO-S13S3G46

4 メンバー

8のガイドは作成済み

コメント1件

Elok tenan Jan sing posting

Haryanto - 返信

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 2

過去 30 日: 13

今までの合計 2,758