Motorola Droid X Motorola Droid X Rear Housing Replacement

はじめに

If one needs access to the inner components of the Droid X or they are needing to replace the rear plastic of the device, this guide will walk a reader through the necessary steps.

必要な工具と部品

手順1 Battery

Motorola Droid X Motorola Droid X Rear Housing Replacement, Battery: 手順 1、 2の画像 1

Motorola Droid X Motorola Droid X Rear Housing Replacement, Battery: 手順 1、 2の画像 2

Locate the power button at the top of the phone. Depress power button for 2 seconds until a menu appears.

編集

手順2

Once the menu appears, select the "power off" option. Wait until the phone is completely off.

編集

手順3

Place thumb on the back cover, and push down towards the bottom of the device. Once the cover releases, pull it away from the phone and set it aside.

編集

手順4

Find the yellow pull tab located in the upper left corner. Pull the tab until the battery dislodges. Grab the battery by the raised edge, and remove it from the case.

編集

手順5

The battery has been successfully removed.

編集

手順6 Motorola Droid X Rear Housing

Motorola Droid X Motorola Droid X Rear Housing Replacement, Motorola Droid X Rear Housing: 手順 6、 1の画像 1

Remove the micro SD card from its connector.

編集

手順7

Motorola Droid X Motorola Droid X Rear Housing Replacement: 手順 7、 3の画像 3

Locate the seam between the back case and the end cover on the top edge of the phone.
Use the plastic opening tool to detach the two clips by wedging the tool into the right side of the seam and moving right to left. Once the cover comes off set it aside

編集

手順8

Motorola Droid X Motorola Droid X Rear Housing Replacement: 手順 8、 3の画像 3

Repeat step 2 on the bottom cover.

編集

手順9

Motorola Droid X Motorola Droid X Rear Housing Replacement: 手順 9、 3の画像 3

Use a T5 Torx screwdriver to remove the screws in each corner of the phone.
The screws are very small so make sure not to lose them.

編集

手順10

Flip the phone over and locate the screw on the middle of the left side. Unscrew it using the T5 Torx screwdriver and set it aside.

編集

手順11

Identify the screw located in the bottom right corner of the battery case. Remove the screw with a T5 (or in some cases T6) torx screwdriver and set it aside.

編集

手順12

Locate the seam along the right edge of the phone. Use the prying tool to disconnect the two clips along the edge.

編集

手順13

Motorola Droid X Motorola Droid X Rear Housing Replacement: 手順 13、 3の画像 3

Locate the two clips on the inside of the case and use the spudger tool to detach them from the case. To detach each clip, use the sharp end to press the small, black plastic in the center of the clip.

編集