はじめに

To reach all the important parts of the phone such as the motherboard and the LCD screen you must remove this metal contraption.

  1. Remove the SIM card.
    • Remove the SIM card.

    • Remove the microSD card.

    • Insert the plastic opening tool between the back cover and the front piece of the case, freeing the plastic clips between the phone.

    • Do this along the back right side of the phone cover until you reach the top.

    コメントを追加する

  2. Use the plastic opening tool to carefully work your way around the top of the phone, freeing the plastic clips.
    • Use the plastic opening tool to carefully work your way around the top of the phone, freeing the plastic clips.

    • Be cautious when using the tool around the top of the device because the plastic case is very thin and could easily be cracked or snapped.

    • After this continue using the tool and pry down the remaining side and the bottom of the phone.

    コメントを追加する

    • With all the plastic clips released, pull away the back cover from the phone to remove it.

    • The back cover is attached to the battery with a large amount of adhesive. Some force may be required to pull the back cover from the phone.

    • The back cover is very durable and will not break from some bending or pulling.

    コメントを追加する

  3. 20ドル以上のお買い上げで送料無料(米国内にお住まいの方対象)
    お支払い手続きの際にはクーポンコードBLUEANDBLACKを入力してください。(米国内にお住まいの方対象)
    20ドル以上のお買い上げで送料無料(米国内にお住まいの方対象)
    クーポンコードBLUEANDBLACKをご使用ください。(米国内にお住まいの方対象)
    • Looking at the top rectangular hump where the camera is located, you will now use the plastic opening tool to remove the camera cover.

    • With the plastic opening tool, apply pressure into any surrounding crease of the camera cover to remove it.

    コメントを追加する

    • Using the T5 and T4 bit pieces, remove the silver screws located around the rear case of the phone.

    • Remove the three 6.7 mm silver T4 screws that are located at the top of the phone.

    • Remove the five 4.0 mm silver T5 screws that are located near the middle of the phone.

    コメントを追加する

    • Using the T4 bit piece remove the three black 4.5 mm screws that are located at the bottom of the phone.

    コメントを追加する

    • Insert the plastic opening tool between the rear case and motherboard assembly.

    • Using the plastic opening tool, carefully work your way around the phone, freeing the plastic clips.

    • Carefully pull the rear case off the motherboard assembly.

    コメントを追加する

    • Using the tip of the spudger, lift the red silicone cover off the battery terminal screws.

    • Remove the two 3.3mm T5 Torx battery terminal screws.

    • Grab the red battery removal tab and pull the battery out.

    • There might be some adhesive between the battery and motherboard assembly.

    コメントを追加する

    • Using the T5 bit pieces, remove the silver screws located around the metal chassis.

    • Remove the three 3.5 mm silver T5 screws that are located near the middle of the phone.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

Nick Kraese

メンバー登録日: 2014年10月08日

637 ポイント

2のガイドは作成済み

チーム

USF Tampa, Team 14-6, Leahy Fall 2014 USF Tampa, Team 14-6, Leahy Fall 2014人のメンバー

USFT-LEAHY-F14S14G6

4 メンバー

5のガイドは作成済み

コメント1件

Where are the replacement chassis parts for this phone??? Thanks Joey K

sailorjt1985 - 返信

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 6

今までの合計 1,517