はじめに

This guide will instruct you in proper cellphone disassembly and removal of the faulty logic board for replacement.

  1. Wedge the opening tool in-between the back cover and the body of the phone in the opening denoted by the arrow.
    • Wedge the opening tool in-between the back cover and the body of the phone in the opening denoted by the arrow.

    コメントを追加する

  2. Once wedged in the opening, slide the opening tool around the side of the phone and remove the back cover, setting it aside.
    • Once wedged in the opening, slide the opening tool around the side of the phone and remove the back cover, setting it aside.

    コメントを追加する

    • Insert the opening tool between the battery and the battery holder and wedge the battery out.

    コメントを追加する

    • Open the plastic cover with your finger to expose the SD card.

    • Use the opening tool to grab the edge of the SD card and pull it straight out.

    コメントを追加する

    • Remove the six 6mm T4 screws with the T4 torque driver.

    コメントを追加する

    • Pop out the volume button with the plastic opening tool.

    コメントを追加する

    • Wedge the plastic opening tool in-between the plastic layer and the front cover.

    • Do not completely separate the two pieces to avoid damaging the ribbon cable inside.

    コメントを追加する

    • Carefully separate the bottom piece from the top plastic piece.

    • Disconnect the ribbon cable connecting the display to the logic board by firmly pulling the cable straight outward.

    • The screen can now be removed.

    コメントを追加する

    • Separate the logic board and the display cover from the back cover and orient the logic board so the camera faces toward you.

    • Disconnect the back cover by wedging the plastic opening tool in between the motherboard and the connector and prying outward.

    コメントを追加する

    • Flip the logic board and display cover over so the camera faces away from you.

    • Bend the two halves of the device away from you to pry the final ribbon connector off the logic board.

      • The ribbon connector is bonded to the logic board with adhesive, simply pull it to break the glue bond.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

No Name

メンバー登録日: 2013年04月21日

25 ポイント

1ガイドが承認済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 1,184