はじめに

Motherboard installation requires a teardown of the device.

パーツ

パーツは必要ありません。

Remove the battery by sliding it down the rails to which it is connected.
  • Remove the battery by sliding it down the rails to which it is connected.

コメントを追加する

Find a flat head or Phillips head screwdriver.
  • Find a flat head or Phillips head screwdriver.

  • Insert the screwdriver into the holes in the plastic rod connecting the key pad guard to the rear casing.

  • Use the screwdriver to push the rods towards each other until they click out of their locked position.

  • Note: This may require a large amount of force.

コメントを追加する

Slide off the antenna guard and locate the four clips on the exterior of the rear casing.
  • Slide off the antenna guard and locate the four clips on the exterior of the rear casing.

  • Simultaneously push the clips outward while lifting the rear casing and keyguard away from the front casing.

  • Remove the key guard from the rear casing by taking it out of its position.

コメントを追加する

Locate and unplug the black component of the antenna from the motherboard.
  • Locate and unplug the black component of the antenna from the motherboard.

  • Under the black component should be a blue component. Unscrew this component in order to free the antenna.

コメントを追加する

Slide the antenna out of the green tubing and slide the green tubing out of it's corresponding hole on the motherboard.
  • Slide the antenna out of the green tubing and slide the green tubing out of it's corresponding hole on the motherboard.

コメントを追加する

Lift the motherboard out of its location in the front casing.
  • Lift the motherboard out of its location in the front casing.

  • Do this slowly and gently so that none of the motherboard's components are damaged.

コメントを追加する

With your new motherboard, hold the LCD side of the motherboard face down. Align the four clips on the front casing with the four notches on the motherboard.
  • With your new motherboard, hold the LCD side of the motherboard face down. Align the four clips on the front casing with the four notches on the motherboard.

  • While doing so, insert the LCD into the compartment in the front casing.

コメントを追加する

Press firmly on the motherboard until it is snug inside the casing.
  • Press firmly on the motherboard until it is snug inside the casing.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Andrew Lam

メンバー登録日: 2012年04月17日

28 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 9-46, Regan Spring 2012 Cal Poly, Team 9-46, Regan Spring 2012人のメンバー

CPSU-REGAN-S12S9G46

5 メンバー

8のガイドは作成済み

コメント1件

Nice, thanks.

Daniel - 返信

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 2,335