はじめに

Use this guide to replace the LCD in your Motorola C350.

パーツ

パーツは必要ありません。

Use your finger to press the button and free the device rear case. You may have to force it a bit more to free its bottom if you open it for the first time.
  • Use your finger to press the button and free the device rear case.

  • You may have to force it a bit more to free its bottom if you open it for the first time.

コメントを追加する

slide the black button to free the battery so you can grab it with your other hand.
  • slide the black button to free the battery so you can grab it with your other hand.

コメントを追加する

You will see one plastic clip on each side of the device. Use your thumbs to push them apart and being able to separate the front case from the device other components. You will see one plastic clip on each side of the device. Use your thumbs to push them apart and being able to separate the front case from the device other components.
  • You will see one plastic clip on each side of the device. Use your thumbs to push them apart and being able to separate the front case from the device other components.

コメントを追加する

Remove the 4 T6 Torx screws Remove the 4 T6 Torx screws
  • Remove the 4 T6 Torx screws

コメントを追加する

Use a metal spudger to pell off the four metal clips and separate the motherboard and keyboard from the main plastic part. Use a metal spudger to pell off the four metal clips and separate the motherboard and keyboard from the main plastic part.
  • Use a metal spudger to pell off the four metal clips and separate the motherboard and keyboard from the main plastic part.

コメントを追加する

The last thing you need to doto access the Logic Board is to separate the Keyboard/Screen block just taking apart with your fingers.
  • The last thing you need to doto access the Logic Board is to separate the Keyboard/Screen block just taking apart with your fingers.

コメントを追加する

Remove the two small metal clips keeping the cables safe.
  • Remove the two small metal clips keeping the cables safe.

コメントを追加する

Use a plastic spudger to pell off the two cables on the back side of the screen.
  • Use a plastic spudger to pell off the two cables on the back side of the screen.

  • There are two very small connectors. Take care of them and replace them if they incidentally fall.

コメントを追加する

Use a plastic spudger to release the disconnected screen.
  • Use a plastic spudger to release the disconnected screen.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Vincent Monteil

メンバー登録日: 2013年07月06日

6,161 ポイント

21のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 440